200250 MultiMates® - Countersunk Rib Head, Needle Point, Twinfast Thread
These screws feature a sharp Needle point for fast drilling into timber or thin metal up to 0.75mm thick, a Twinfast thread for rapid installation and self countersinking ribs under the head to ensure a flush or below the surface finish in the material being attached. Available in Zinc Yellow (ZY) finish and Galvanised for higher corrosion resistance when used externally. Also available in Collated plastic strips, refer to Collated screws section.
• Instant piercing
• Fast drilling and easy to use
• Instant piercing
• Won't skid, wander or slip
• Minimal drilling swarf
• Ribbed Countersunk head self countersinks into fibre cement board or timber
• Available in a several lengths
• The Zinc Plated finish is recommended for internal use only but can be used externally if adequately painted or protected
• 30mm length also available with High corrosion resistant coating suitable for use both internally and externally
• Complies with AS3566.1 & 2
• Fast drilling and easy to use
• Instant piercing
• Won't skid, wander or slip
• Minimal drilling swarf
• Ribbed Countersunk head self countersinks into fibre cement board or timber
• Available in a several lengths
• The Zinc Plated finish is recommended for internal use only but can be used externally if adequately painted or protected
• 30mm length also available with High corrosion resistant coating suitable for use both internally and externally
• Complies with AS3566.1 & 2
1/ Ensure the correct driver tool is fitted to your power drill or screw driver.
2/ Place the screw on the driver tool and position it onto the materials being fastened.
3/ Push sharply to create a centre mark and to prevent screw wander.
4/ Squeeze trigger and maintain steady, constant pressure until the screw has drilled and fastened.
Recommended Driving speed is 1,000 r.p.m for fixing into timber and 2,000+ r.p.m. for fixing into thin metal up to 0.75mm thick.
2/ Place the screw on the driver tool and position it onto the materials being fastened.
3/ Push sharply to create a centre mark and to prevent screw wander.
4/ Squeeze trigger and maintain steady, constant pressure until the screw has drilled and fastened.
Recommended Driving speed is 1,000 r.p.m for fixing into timber and 2,000+ r.p.m. for fixing into thin metal up to 0.75mm thick.
• Ideal for attaching Villaboard, fibre cement sheets, panels or boards to timber or thin metal up to 0.75mm thick.
| Size | Coating | Pack Type | 500 Y Drilling Capacity in Steel | 510 Y Rec. Embedment in Timber | 520 Y Thread Length (TL) | 530 Y Driver Tool | Code |
|---|---|---|---|---|---|---|---|
| 8g-15 x 20mm |
|
||||||
| 8g-15 x 30mm |
|